Error Printer Canon Pixma iP2770 - Printer error or a problem on Canon iP2770 printer then provide the best solution improvement tips and tricks:
- Three times blink Orange 1x green, the most frequently found foreign objects in the near roller, if that can happen to a rather severe mechanical damage, Solutions,, loading printer (if it is not under warranty, if you still take it to a service center where you membelli printer) check whether there is a foreign object clogging, repair or replace mechanical
- Four times blink Orange 1x green, Wante Ink Pad Full, solutions use software, Printer Reset
- Five times Blink Orange 1x Green, Black or Color Cartridge can be defective Solutions,, Check cartridge, cartridge chip use wipes to clean dirty with ink may cause not connect, if still g can, replace cartidge,,
- Seven times Blink Orange 1x green, Damaged Color Cartridge / off, Solutions, Replace Color Cartridge,,
- Seven times blink Orange and green alternately, Waste Ink Pad Full, Ink Absorber Full,, Solutions,, First for printers that are not infused / tp not given an intravenous drip disposal, clean the ink absorbent foam in the bottom of the printer / could also be replaced, then reset using software resetter printer.
- Eight times Blink Green Orange one time, ink tank full, Solutions,, reset using software resetter printer,
- Thirteen / Sixteen times blink Orange 1x green, Cartridge is not installed properly, the image appears when the print cartridge jamming like apart up on your screen, Solutions,, Press and Hold Resume button (below the power button) approximately 10 second.
- Fourteen / Fifteen times Blink Orange 1x green, Black Cartridge Damaged / off, Solutions,, Replace Black Cartridge
How to Reset iP2770
Log into Service Mode iP2770 :
- The printer is turned off and the power cord is attached.
- Press the RESUME button two seconds and then press the POWER button until the green light on (when pressing the POWER button, Resume button ... jgn removed first)
- Then release the RESUME button, but do not remove the POWER button.
- While the POWER button is still depressed, press the Resume button 6 times. Led will flash alternately orange last green with a green flame. (not to be mistaken 4x because the printer will die totally, but it is temporary too) Then ...
- Release both buttons simultaneously.
- Led will blink briefly then will flash GREEN.
- The computer will detect the new device, just ignore it ...
- This situation shows the iP2770 printer is in a state of SERVICE MODE and ready to be reset.
- File Exctract iP2770 Resetter
- Prepare 2 paper in the printer (to print at the time of the reset process).
- Run the program iP2770 Resetter
- Click "PLAY", then the printer will proceed, then iP2770 will print one page with the words " D = 000.0 "
- Turn off the printer by pressing the POWER button.
- Done ...
Download Driver Canon Pixma iP2770
Download Resetter Cannon Pixma iP2770
Posted by 8:22 PM and have 3 comments, Published at